Avanti Clearance!

[mfg]

Necessary clearance to install Chevy V8’s under the hood of Avanti ll’s was achieved by shimming the body up from the chassis about 2”, and  also redesigning the engine fan shroud…True?

[Zedman]

I reckon the Fan Shroud might well have needed tweaking so Ill say yes to that, but two inches of shim..... I'll say no to that.

[mfg]

5 hours ago, Zedman said:

I reckon the Fan Shroud might well have needed tweaking so I’ll say yes to that, but two inches of shim..... I'll say no to that.

Zedman… Happy Holidays!… The 2” came from a pretty knowledgeable Avanti restorer… but I included “about” to leave some wiggle room…..

But assuming “about 2” is correct, would you say TRUE or FALSE to this question?

[Nelson]

Ive owned a few of the Avanti II s but never worked on them much. I know they did jack the body up off the frame at the cowl about two inches  maybe a little less but that would end up being more up at the radiator. As for the radiator shroud I would think, like Zedman, that some tweaking would have been done at the radiator shroud but I could be wrong.

[mfg]

1 hour ago, Nelson said:

Ive owned a few of the Avanti II s but never worked on them much. I know they did jack the body up off the frame at the cowl about two inches  maybe a little less but that would end up being more up at the radiator. As for the radiator shroud I would think, like Zedman, that some tweaking would have been done at the radiator shroud but I could be wrong.

I believe both you guys are on to this… concentrating on the reworked shroud is the key here!… Well done!

The actual answer to this trivia question is …False… Because in addition to the reworked fan shroud, a 1/4” filler panel or ‘shim’ was needed between the top radiator mounting and the reworked shroud to give just enough fan clearance.