Intake manifold and carburetor change

[Puffdaddy#1]

Rqb 1898, My 72/73 400 cu. in, I'm looking to swap to a four barrel carb set up, any good recommendations?

[wildfelr]

RQB3263/81/305   YES I DID THIS ABOUT 2 YEARS AGO SUCCESSFULLY ..... Edelbrock alum intake   and Holly carb    both from Summit....worked fine right out of the box ....  be advised you may have hood clearance issues.... i was given a low profile  360 degree open air filter  that extends down over the carb a bit to solve the problem.... these are prob available from Summit also ....use RTV and not the worm shaped gasket on the front and rear ends of the block to manifold mating surfaces.... good luck ....see ya on the Boulevard .... Bill in Florida

[Gunslinger]

Call Summit Racing’s tech line…explain what you have and your concerns.  They will give you solid recommendations.  

[Puffdaddy#1]

9 hours ago, wildfelr said:

RQB3263/81/305   YES I DID THIS ABOUT 2 YEARS AGO SUCCESSFULLY ..... Edelbrock alum intake   and Holly carb    both from Summit....worked fine right out of the box ....  be advised you may have hood clearance issues.... i was given a low profile  360 degree open air filter  that extends down over the carb a bit to solve the problem.... these are prob available from Summit also ....use RTV and not the worm shaped gasket on the front and rear ends of the block to manifold mating surfaces.... good luck ....see ya on the Boulevard .... Bill in Florida

 

[Puffdaddy#1]

Thanks gonna look into that, looking for a bit more performance ya know?