Dunkin Posted March 28 Report Share Posted March 28 Anyone know what the correct width of the factory Hidem Gimp/piping is for these seats? Thanks. Link to comment Share on other sites More sharing options...
Nelson Posted March 29 Report Share Posted March 29 I know it’s narrower than what you typically see on the reupholstered seats out there. Link to comment Share on other sites More sharing options...
Dunkin Posted March 29 Author Report Share Posted March 29 Thank you, that is correct. Link to comment Share on other sites More sharing options...
1963r2 Posted April 2 Report Share Posted April 2 (edited) I thought it was around 12mm. I will check when I get home but it won’t be for a couple of weeks. pb ps I’m trying to get some made up for my seats as well. pps do you have the chrome pieces the hidem slots into ? That would be the width you need. Edited April 2 by 1963r2 Link to comment Share on other sites More sharing options...
Dunkin Posted April 2 Author Report Share Posted April 2 (edited) I believe 1/2 inch is the correct width. Edited April 3 by Dunkin Wrong information. Link to comment Share on other sites More sharing options...
Avanti1963! Posted April 2 Report Share Posted April 2 If i understand your question correctly, it's not even close to one inch wide. It's "much" narrower. Link to comment Share on other sites More sharing options...
Dunkin Posted April 3 Author Report Share Posted April 3 Thank you, I wrote it wrong, it is 1/2 inch, I corrected it. Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now