Avanti Pulleys!

[mfg]

The difference in diameter between Studebaker Avanti standard and high output supercharger pulleys is ......?...... inch.

1) 3/16.....2) 1/4.....3) 3/8.....or.....4) 5/8

 

Edited April 17, 2021 by mfg

[mfg]

No thoughts here?

[1963r2]

1/4 inch

 

 

[pantera928]

3/16"

[mfg]

On 4/24/2021 at 7:26 PM, 1963r2 said:

1/4 inch

 

 

Sorry, not 1/4"

[mfg]

8 hours ago, pantera928 said:

3/16"

Nope, not 3/16" either!

[Dwight FitzSimons]

I'm going to guess 5/8"  The pulley on one of my cars (that I believe to be HO) is about 5.5" in dia.  My R2 Avanti is out in the rain, and there's skunk smell out there, so I believe I'll wait until morning to measure it.  I chased that skunk off my porch yesterday, but apparently he's back.

--Dwight

Edited April 6, 2022 by Dwight FitzSimons

[mfg]

8 hours ago, Dwight FitzSimons said:

I'm going to guess 5/8"  The pulley on one of my cars (that I believe to be HO) is about 5.5" in dia.  My R2 Avanti is out in the rain, and there's skunk smell out there, so I believe I'll wait until morning to measure it.  I chased that skunk off my porch yesterday, but apparently he's back.

--Dwight

I believe 5/8" is CORRECT!

(and best of luck with the skunk!)

[Dwight FitzSimons]

I'm not making up the story about chasing away a skunk, just stretching the truth a bit.  Actually, I was out after dark and walked back to my porch oblivious to the skunk on my porch eating the cats' food.  When I stepped onto the porch it trundled off and retreated without incident.

I wasn't so lucky when I was about 6-7 years old.

--Dwight