Pin and Bolt. Upper Control Arm Pivot.

[Leo B]

Do I have the correct Upper Control Arm Pivot Pin #524227 or is it meant to be like this?
I have correct size bolt 3/8 and the hole for that is not exceptionally loose. The Pin locks easy when the bolt is tightened. But...
The pin groove allows for a lot of lateral movement and the groove is wider and deeper than intended for a 3/8 bolt. I can fit about a 0.6 inch bolt in the groove. The 3/8 bolt couldn't have made that groove. This greatly affects, among other things, caster adjustment.

Edited 4 hours ago by Leo B
Text

[mfg]

If the bolt is cinched up tight, there will be no movement between upper pin and the king plan.