'63 R1 Alternator Replacement

[DobbM]

Trusty multimeter in hand, I'm left to determine that I have a bad diode in my alternator.

I've been perusing the forums and https://studebaker-info.org/Tech/Bhend/avantalternatorarticle1.pdf by Bill Henderson. 

(Awaiting the shop manual to arrive.)

I have a call into a local auto electrical rebuild shop and I'm poking around the alternator. I'd love to have a backup, like one of the Honda or Toyota alternators like others have done so I can still drive my daily while the original is being rebuilt. 

I'm not a good electrical diagram reader. I have three wires coming from the harness to the alternator, white (or so faded they look yellow to me), white with black stripe and white with red stripe. The resister looking thing attached to the back of the alternator -- is this the Prestolite regulator? (see img 1). Whatever it is, it is not actually attached to the alternator, as I found it loose, not broken, in the boot. (Img 2). The red stripped wire goes to the terminal with the boot, the black-stripped goes to the other terminal, and the solid looks like it is being grounded to the post that holds the "regulator".

Thoughts/Comments/Suggestions welcomed.

-Dobb

  

 

[DobbM]

Atlas 710

38-42A

[brad]

The round "can" is a radio noise suppresser condenser, or more commonly called a capacitor. Not any sort of voltage regulator. The other wiring seems correct. The white with red stripe is to the main terminal, the one with the black stripe goes to the smaller terminal, often a spade push on connector if original. Then the plain white wire is ground to the case. The voltage regulator is in front of the master cylinder on the drivers side inner fender.

[DobbM]

Thank you. So it's okay that the capacitor is not actually hooked up to anything? How would I know if I need to attach it?

[Dwight FitzSimons]

9 hours ago, DobbM said:

Thank you. So it's okay that the capacitor is not actually hooked up to anything? How would I know if I need to attach it?

You would have static on your AM radio.

[DobbM]

(still awaiting my shop manual)

Would one of these be the external regulator? 

[mfg]

16 minutes ago, DobbM said:

(still awaiting my shop manual)

Would one of these be the external regulator? 

Yes … black ‘box’ marked 2

[DobbM]

Ok, I installed the new alternator and the car is running much better. However, the battery is not being charged by the alternator. Also, the ignition powered wire isn't delivering 12v. My only assumption is that the external regulator is actually bad. I rewired according to the above referenced article by Bill Henderson. 

Next step is to wire the BAT alternator terminal directly to the the battery, with inline 60amp fuse, and just bypass the regulator entirely. 

My next question is how to get 12v to the alternator when the ignition key is "on"? 

(My shop manual is in the mail and should be here Monday.)

Thank you everyone.

[mfg]

59 minutes ago, DobbM said:

Ok, I installed the new alternator and the car is running much better. However, the battery is not being charged by the alternator. Also, the ignition powered wire isn't delivering 12v. My only assumption is that the external regulator is actually bad. I rewired according to the above referenced article by Bill Henderson. 

Next step is to wire the BAT alternator terminal directly to the the battery, with inline 60amp fuse, and just bypass the regulator entirely. 

My next question is how to get 12v to the alternator when the ignition key is "on"? 

(My shop manual is in the mail and should be here Monday.)

Thank you everyone.

Do you have a voltmeter?… That would identify how much current and where it is going… or not going…. Even a basic 12V test lamp will allow you to ‘see’ the electricity.