Jump to content

DaytonaR2

AOAI Forum Members
  • Posts

    18
  • Joined

  • Last visited

Everything posted by DaytonaR2

  1. Other than the rear windows what holds the rear interior sail panels to the body? Are they glued? Getting ready for paint and I need to remove rear exterior emblems.
  2. Ditch the resistor as that was only for original points system (to save points). Electronic distributor needs 12 volts as a constant.
  3. Very easy job to do yourself with the rebuild kits. These are Bendix units, so YouTube has plenty of guidance. Early mustangs and corvettes used basically the same units except for the hose connection points. Hard part is getting the units off of the car.
  4. I just took the old seal to them and the shaft and they measured it
  5. I found a replacement seal for the top seal at an agriculture hydraulic business. Worked perfectly. I bought a couple
  6. The back seat upper cushion has likely crushed the rubber vent hose flat. That is what mine was... Easy to check
  7. One huge problem in cooling problem is the open bottom of the fan shroud. This creates a leak of fan vacuum draw from the radiator. This winter I plan to make a mold to create continuance of the shroud radius around the bottom out of fiberglass to maintain the fan vacuum draw through the radiator. I intend to make it a simple bolt on piece. This should aid cooling during stop and go traffic and parades etc. As it is currently a significant air draw leak. I am doing this even though mine does not get hot. I just want as much draw as I can pull through the radiator so that the ac condenser in front of it is more efficient during stop & go.
  8. I just replaced all of the hoses on my tank and found where the vent line rubber hose where it passes in front of the fuel tank was crushed flat. Likely from the back seat and time. Previous owner had installed an electric fuel pump and my guess is that was done to try to compensate for what had to be a hard to draw fuel from tank.
  9. Be mindful that the holes in the sender and gasket are specific to orientation. They holes are not equally spaced. My new sender had the float swing toward the passenger side versus the drivers side on the original. That is where the holes aligned. It seems to work great. Far better gasket too.
  10. Does anyone aware of any replacement seat springs (rear) being available? Mine are rusty beyond imagination.
  11. Move your wires around the cap in either direction to make clearance from the vac pot. Move the distributer base in the same direction you move the wires. Then set the timing again. The base does not really care where it is positioned, make it have clearance and adjust timing accordingly
  12. My intake is off now and the loop pipe appears to be stainless. I doubt it has a leak, just plugged up.
  13. I had just purchased a Bowden cable with a nice chrome handle on the end on Amazon. After cutting the external sheath to the correct length I used a cable "B" nut from Aircraft Spruce. Bend the excess internal cable over (90 degrees) after the "B" nut for a safety against ever slipping.
  14. Do you have the panels that go on the forward part of the console that have the side outlets for air-conditioning?
×
×
  • Create New...