Avanti Bumper!

[mfg]

Avanti design team member Bob Andrews once said that the tooling for the Studebaker Avanti's front bumper was.....................?

1) Very complicated...........2) Prone to quickly wearing out...........3) Slightly distorted in profile.......or.....4) Very expensive

[mfg]

No thoughts on this one?

[r1lark]

I'll say 3) Slightly distorted in profile.

[mfg]

14 hours ago, r1lark said:

I'll say 3) Slightly distorted in profile.

Sorry, # 3 is not correct!

Edited August 31, 2017 by mfg

[studegary]

I'll say no. 1) very complicated.

[mfg]

11 hours ago, studegary said:

I'll say no. 1) very complicated.

Sorry Gary, # 1 is the wrong answer!

Edited September 1, 2017 by mfg

[r1lark]

Then it must be 4) Very Expensive.

[mfg]

54 minutes ago, r1lark said:

Then it must be 4) Very Expensive.

And you must be .....CORRECT!