rear bumper clearance

[IdahoBen]

Installed the rear bumper and have excessive side clearance.  Over an inch from the fiberglass to the mounting pad on the bumper.  I think I need to bend the bumper.   What is the standard gap?  As it is the bolts do reach.

[mfg]

There’s a 1/4” rubber shim that fits in between the bumper and the fiberglass body which will fill some of that gap.

The gap on your Avanti does look excessive.

I’d add a second rubber shim, then tighten the bolt to crank it in.

[regnalbob]

The width of the bumper between inside edges is approximately 63 inches.

The gap at the front edge is 1/2 inch.

The gap at the shim is 5/8 inch.

Edited 9 hours ago by regnalbob

[IdahoBen]

dont think I like the idea of cranking on bolts to put that kind of constant strain on the body.   I will try to bend the bumper tomorrow.  Thanks regnalbob for the pictures and the measurements.

[mfg]

51 minutes ago, IdahoBen said:

dont think I like the idea of cranking on bolts to put that kind of constant strain on the body.   I will try to bend the bumper tomorrow.  Thanks regnalbob for the pictures and the measurements.

I’d go easy when doing this .. but it’s the bracket itself taking the strain...
You don’t want the bumper too close to body, as shown in photo, as a possible side impact will mean certain fiberglass damage…..

Also, those bumper sides come in fairly easy when tightening the side bolts… just go slowly… Trying to straighten the bumper off the car can be done, however that’s unfortunately a good way to crack the chrome plate.

Edited 1 hour ago by mfg
Added text