Rebuilding Manual Window Regulator.

[Luma]

Need some tips to replace the crank area with new parts. Looks like I have everything (driver side crank) to replace but will be unable to press in holding pins on cover without separating from rest of the entire 1 piece mechanism assembly. Any ideas appreciated.

[Zedman]

I believe you will need to remove the original Rivets. These can be replaced with similar rivets if you trim the length so when assembled , you have only 1 x the diameter protruding. These can be gently mushroomed over with a hammer (buck the head end on a soiid flat steel surface) to secure the cover once again. Tinmen's or pan head rivets ought to do. You might even be able to use suitably sized flat head nails as substitute rivets (done that before). Pop rivets might do but use steel ones not Aluminium otherwise they might loosen up in service.