A83 Posted Wednesday at 09:37 PM Report Posted Wednesday at 09:37 PM Only 1983 AVANTI when I raise the power window all the way up it hits the vent window chrome and pushes it up off the glass a little bit How can I properly correct this ? All advice appreciated thank you A83
A83 Posted Wednesday at 09:38 PM Author Report Posted Wednesday at 09:38 PM Oops only should read On My …. Sorry
ronmanfredi Posted Wednesday at 11:20 PM Report Posted Wednesday at 11:20 PM The "window stop" for its maximum height is adjustable. Remove the door panel; towards the rear of the door (latch side) and close to the top, there is a bolt that holds the adjustable stop in place. Lower the window and look down into the cavity from the top of the door and you will see the "stop". It's just a flat piece of metal attached to a bracket that you move up and down. Loosen the bolt, lower the stop a little. tighten, raise the window and check the new maximum window height. Once you have it where you want it then tighten the bolt and install the door panel.
wdaly Posted Thursday at 05:00 PM Report Posted Thursday at 05:00 PM You may also want to consider buying the Shop Manual. Although you don't have a '63 - '64 a lot of the mechanisms remained the same!
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now