tranny crossmember needed

[dixchief]

1963 Avanti was sitting for a couple years waiting to be reassembled. all components were rebuilt.

gremlins (or trolls) snuck in and stole the steel cross member that supports the auto tranny. also missing are the engine brackets. i believe I can buy the brackets but the crossmember is not available.

if you have the crossmember(looks to be stamped steel-2 frame holes on each side and tranny rubber mount studs about 15" apart),

contact me ASAP at dixchief@gmail.com please.

or if you can tell me where to find one

the car has been painted and the engine is ready to install

TIA

Richard 407-417-4882 dixchief@gmail.com

[brad]

Same as any Lark, The outer ends cut flush with the frame.

[dixchief]

Thanks to Henry in Tampa, I have a cross member. Thank you Henry. anyone know if there is a spacer on one of the tranny mounts? TIA

[brad]

yes, there is a spacer under the left transmission mount.

[dixchief]

is this a standard size or will it vary - determined at installation? TIA

Richard

[64studeavanti]

According to the parts catalog it is part # 527974 and is 3/8" thick. It goes on the left (drivers) side.

[dixchief]

thank you