Leo B
-
Posts
476 -
Joined
-
Last visited
Everything posted by Leo B
-
Hi, I have replaced all the bushings and king pin bearings etc. In order to adjust the maximum caster, I have installed shims on the lower control arm at the rear and the upper one at the front. I thought that this way I would get the right angle at which I could get maximum rotations with the outer pin. While searching for articles on the subject, I found your old post today. You have apparently done the same steps as me.
How many degrees of caster did you get with your steps?
-
I ended up with 1.75 on the passenger side and 1.50 on the drivers side. The camber was way off on the passenger side and I ended up slotting the top of the frame to get the camber at zero. The car hadn't been wrecked and I had read that this was a common problem with some Avanti IIs.
-
