mfg Posted October 30, 2021 Report Posted October 30, 2021 On Studebaker Avantis & early Avanti ll's, if there is insufficient clearance between engine front pulley and steering power cylinder end (on bellcrank) a 'quick' way to improve this clearance is to ..................? (This is after front engine mounts have been inspected and determined to be OK)
silverstude Posted November 3, 2021 Report Posted November 3, 2021 Lower the center pin housing. I think I found that 3/8" was about the max.
mfg Posted November 3, 2021 Author Report Posted November 3, 2021 16 minutes ago, silverstude said: Lower the center pin housing. I think I found that 3/8" was about the max. Right!....install shim washers between center bearing housing and bottom of crossmember to, in effect, lower the center bearing housing and bellcrank along with it.
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now