Jerry1963 Posted January 12, 2021 Report Posted January 12, 2021 I am working my way through the engine compartment and need to work on my radiator support but cannot get it out. With all bolts removed I can move it around but due to the protruding frame/body supports I cannot get it out in one piece. Is there as secret for removal of the support or do I need to cut it to get it out? Thanks Jerry
64studeavanti Posted January 12, 2021 Report Posted January 12, 2021 You either need to raise the body a little or cut a little off the inner fenders. The support was installed before body was mounted to frame.
Jerry1963 Posted January 13, 2021 Author Report Posted January 13, 2021 Thanks for the information. I was going to cut the support, but with your comments I believe I will cut the inner fenders.
64studeavanti Posted January 13, 2021 Report Posted January 13, 2021 (edited) You should get a copy of Stan Gundry's book "What the Shop Manual Won't Tell You". It has info on this as well as many other useful bits. I believe you can order it from his web site. http://talkshop.blogs.com/avantipublishing/ Edited January 13, 2021 by 64studeavanti
Whlnut Posted January 21, 2021 Report Posted January 21, 2021 (edited) I removed the support by trimming the right inner fender panel at the lower front. Then move driver side of support to where it can recess slightly to the outside. This allows you to move pass side rearward, then driver side, then up and out. Edited January 21, 2021 by Whlnut Add
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now