Jump to content

Rear Leaf Spring Replacement - "driveline angle issues" ?

Recommended Posts

In the quiet of fall, I'm considering replacing the rear springs on my '63 (now arcing down at both ends, both sides).  Eaton Detroit Spring can supply 5 or 6 leaf springs (standard or HD, I presume) in 3-4 weeks.  Some have told me in replacing the springs I "may" run into a driveline angle issue, resulting in vibration.  Further, I am told, when Studebaker would receive a spring shipment of 50 or so units they would road test to determine what size shims would need to be placed where to settle driveline angle/alignment on that lot of springs/vehicles and this the number of shims and shim sizes could vary considerably from one lot to another.

Suspect my 57 year-old shocks are original and I'd replace at the same time.

Comments, please...   Thanks!

Link to post
Share on other sites

If you replace the springs back to the stock ride height, you should be fine. As the springs settled over the years, did you constantly change the shims between the bell housing and the motor mount? (of course not) If everything is as it was built, then you will have no problems. On Automatic transmission cars, there is one   3/8"  spacer under the drivers side of transmission mount between the mount and the crossmember. On manual transmission cars there are two  1/2" spacers between the bell housing, and the top of the mount.  You will never need to change them. If you develop a vibration, then either your mounts are soft and collapsed, or your U-joints are bad, or a weight fell off the driveshaft where it might have been spot welded on. 

Link to post
Share on other sites

No, If your pinion angle is 2 degrees up, then your trans yoke angle should be 2 degrees down. You ideally do not want a straight line in a drive line, you need some angle to grease the u-joints. 


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...