Ron Dame Posted February 7, 2018 Report Share Posted February 7, 2018 As I keep plugging away at getting the R2 roadworthy, I found my newest most hated job: Lower radiator hose. Between the trans cooler lines at the lower end and the lack of access from the supercharger and brackets, plus idiotically located hose clamp screws (thanks PO) and sticking old hose, it was a 1 1/2 hour job, and my arms are bruised to hell. I'm tired as hell Link to comment Share on other sites More sharing options...
PackardV8 Posted February 7, 2018 Report Share Posted February 7, 2018 Yes, that's a bad one. No, it's far from the worst one. Maybe, hope you never have to remove the core plugs and rod out the block. Replacing all the PS hoses is right up there also. jack vines Link to comment Share on other sites More sharing options...
mfg Posted February 7, 2018 Report Share Posted February 7, 2018 That is a tough one!...If you had the time, it would have been a good opportunity to pull the blower for a good draining....or even split the cases to REALLY give it a good cleanout! Link to comment Share on other sites More sharing options...
Ron Dame Posted February 8, 2018 Author Report Share Posted February 8, 2018 I've rodded out the block on a Lark and a Hawk. Sucks. I can see how an Avanti is worse. I hope mine are fine, there is evidence that the plugs have been changed at least. I hope PS hoses hold (what makes it worse than any other Studie?) Link to comment Share on other sites More sharing options...
Kennie B. Posted February 8, 2018 Report Share Posted February 8, 2018 The lower hose isn't any better on an R1 with A/C. How is it that people cn get the hose clamps in some of those positions and so damned tight?! Still, beats doing power steering hoses or rodding out the block. Link to comment Share on other sites More sharing options...
wwundt Posted February 9, 2018 Report Share Posted February 9, 2018 Why are some hoses hard to remove? Shop Manual states this (in reference to replacing heater hoses at the heater control valve: apparently they are glued on! "Use special gasket shellac to install the hoses onto the control valve. The shellac will make it easier to slip the hoses onto the fittings; when it hardens, the shellac will ensure a water-tight seal, strengthening the joint against leaks when the system is under pressure. Never use soap, lubricant, or non-hardening sealer on the hose connections." Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now