Greg Stoyer Posted March 3 Report Share Posted March 3 Current project is replacing window door seal (anti-rattle) on drivers side. Have panel, tape off, and have followed the steps in the workshop manual (1-5) to remove door window. Have the window loose and the ventilator assembly loose, but the window seems stuck toward the rear of the door. I can lift the front part, but not the back, so I can't remove it. What did I miss? Link to comment Share on other sites More sharing options...
ronmanfredi Posted March 3 Report Share Posted March 3 With the 2 regulator arms popped out of the lower window track and the 3 bolts and 2 nuts removed from the ventilator (with the 2 screws turned in) the window should lift right up and out (while tilting the ventilator forward and slightly up). Double check and be sure the regulator arms at the bottom of the window track are popped completely out of the bushings Link to comment Share on other sites More sharing options...
George Rohrbach Posted March 19 Report Share Posted March 19 (edited) Greg, were you ever able to get your window out? On my Avanti, the top of the (rear) window track was pinched at the factory. I had to open the end of the track back to the original opening size. After I do everything to the mechanism, and put the window back in, I plan to pinch it semi closed again. Driver side before. Pass side after bending open. Edited March 19 by George Rohrbach Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now