Jump to content

Uh Oh Shift Lever to Transmission Rod Installation


Recommended Posts

Posted

Just put the engine in. Automatic. 63 Avanti. The shift lever rod is attached to the gear shift side. It is hanging down, not attached to the transmission. I can't even see the hole on the lever on the transmission where the rod attaches. The rod won't even clear the exhaust and transmission to get there anyway. (The rod does not look exactly like the rod shown in the parts manual, further complicating things. But it looks like it was always attached to the gear shift.) Any help appreciated. I hope I do not have to move the engine back out. At this point I think I would even cut a hole in the fiberglass transmission tunnel.

Posted

My trans to gearshift rod has about an 80 degree bend in it. The end that attaches to the transmission has threads for a nut. I see the parts book has a spring washer and cotter pin. Do I have an incorrect part? Did they make more than one?

Posted

Here is a picture of the rod that was attached to the floorshift. The end is threaded, not a hole for a cotter pin. I put those nuts on there.

IMG_4549.JPG

IMG_4550.JPG

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...