Thank you,
How far away from the raised area on the trunk lid should edge of surface A be. Or putting it another way how far from the outer edge of the trunk lid should the edge of surface A rubber be.
I have a 1972 Avanti II RQB 1882 with round headlight trim as was used on 1963 production. I always have thought that my car might have been in an accident and the front end was repaired to with the 1963 trim. In the Avanti magazine issue 203 there is an article about a 1972 or 1973 (identified as a 1972 in the pictures of the 2023 International meet attendees and as a 1973 in the article entitled Black Beauty on page 20 of the same issue with round headlight trim. One of the pictures shows the serial number to be RQB 1984. Was there an option to have round headlight trim in 1972 or 1973 when these cars were built?
Specifically which parts are you going to have to replace. I have not taken my 72 to the alignment shop yet but i would like to have all the parts available in case I have the same problem.
I have a 1972 Avanti II. I have been told that my car has a Lark convertible frame and the front suspension is also the same as a Lark. I am trying to determine what the caster angle should be. The alignment shop report shows the caster angles as -2 degrees on both wheels. From the Avanti Workshop Manual the caster angle should be = / - 3/4 degrees.
Any insight on this issue would be appreciated
Dan
Has anyone found modern three point seat belts that do away with the need to attach the shoulder belt to the lap belt and that bolts up to the attachment points on my 72 Avanti