Shoovel

In the master cyl box it stated not to bench bleed. So I didn’t.

Folks, I need your help. I’m working on a 64 Avanti without the “anti roll” feature. I’ve replaced the front caliber blocks, rear wheel cyl, front & rear flex lines and master cyl. I don’t know what I have done wrong, cause I can’t get any pressure when bleeding. I tried having my helper push down on the pedal and hold it to the floor, I got air out of the RR, and LR, then RF and LF, but I cannot get any pedal. I had my helper pump the pedal with the same results. All parts from Studebaker Intl. Any help will be greatly appreciated. Thanks.

Thank you for the info.

Folks, New here. I’m helping a friend who has a very nice 64 Avanti. I am going to replace the valve cover gaskets, but there is no info in the shop manual. On the left side do I have to remove the brake booster? I also was going to check valve clearance, but the manual states to do this with the engine running. What’s a good cold setting for clearance with the engine not running? Thanks Tom