Jump to content

Recommended Posts

I recently purchased an '85 RQB.  I noticed that the corner of the hood, pax side, near the windshield, where it comes up, was slightly higher than the other corners of the hood (1/4-1/2 in. gap) .  I tried to adjust the conical tip (just below the coil spring that is between that tip and the underside of the hood).  I turned the slot at the bottom of the tip 1/2 turn CW and closed the hood, with some improvement noted (the corner was a little lower... gap decreased).  So I turned the slot/cone another 1/2 turn CW and closed the hood.  Now I can't get the #&!@^$ thing open!!.  The driver's side releases but no joy on the other side.  To add insult to injury, I had a small box of sockets and ratchets on the air cleaner cover.   Any advice would be greatly appreciated.

Just call me dumb azz.


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...