Jump to content

windsheild mouldings


foxhole

Recommended Posts

changing the windsheild on this 84 and am having problems determining what is holding the side mouldings on other than 2 tubes of urethane, 1tube of silicone and about 3/4 of a tube of sikaflex,by looking at it i figure its probably either spot welded to the drip rail and has screws hiding below the door seal or is attatched through the inside like a rolls but would prefer to know for sure before i start ripping anything extra apart as everything is rock hard and will likely not just go back together.

Link to comment
Share on other sites

On my 85, I found that even after the small screws on the side were removed it was extremely difficult to remove the stainless steel trim. Did a lot of delicate prying with scrapers, small wide pry bars, and anything else I could find. Finally got them off with almost no damage: Good Luck! Bob

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...